Cooling Tank Machine in Polyethylene Pipe Production Line
Cooling Tank is located in the middle of Polyethylene Pipe Production Line after the Vacuum Tank and before the puller and marker.
Cooling tank has duty of final refrigerate of the polyethylene pipe, and number of cooling tanks and water spray depends on the speed of production line and the and size of produced polyethylene pipe that with increasing of production line speed, increase number of tanks in circuit. Technology used in this part of production line (cooling tank), despite its simplicity, it has a special complexity and precision, and number of spray nozzles and spacing of tanks from each other must be carefully calculated, and cooling is done properly, and pipe produced has a good quality and level, which, according to need and size and dimensions of produced pipes, are placed in the orbit for cooling.
In the production of down and small polyethylene pipes, a cooling laver is used, and pipes along course and after the tank vacuum are sinked in the cooling laver, and passed through the water. Cooling tank is highly dependent on the water temperature, and water should have a fixed and standard temperature, which will perform cooling operation correctly, otherwise, pipe will not cool properly, and in other parts of polyethylene pipe production lines, there may be created problem, and one of simplest problems, duplexing of polyethylene pipe.
Monitoring of polyethylene pipe production line
Polyethylene pipe mold
Haul off of Polyethylene pipe
Polyethylene pipe marker
Equipment for production line of polyethylene pipes and connections
Production line of single wall polyethylene pipes
Double wall polyethylene Corrugated Pipe production line